Lanai floor, full-flake system
The bare slab stained fast and felt slick when wet. We ground it, sealed it with a full-flake system, and added grip to the topcoat for wet feet.
The outdoor rooms Ocala lives in, coated for sun, water, and bare feet — with grip where the floor gets wet.
Tell us about the floor. We call back with a time to come look — the written price comes after the in-person look, before any work starts.
Rather talk? Call (352) 555-0148.
A lanai or pool deck floor takes full sun, daily water, chlorine splash, and bare feet. A smooth, glossy garage finish is the wrong spec out here. Outdoor floors need a sun-stable top that will not amber or chalk, and texture you can trust with wet feet.
We coat lanais, covered patios, porches, and pool decks with the same prep as a garage — grind, repair, moisture check — and a finish built for outside: polyaspartic tops for sun, flake or texture for grip. The lanai is a living room in most Ocala homes, and we treat its floor that way.
Failed deck paint is the usual starting point: chalky, peeling, hot underfoot. It all comes off with the grinder. Cracks and settled spots get repaired and ground flush before the new system goes down.
Fit matters out here more than anywhere. A deck with drainage trouble or a slab that stays damp needs a plan, not just a coat. We will confirm fit at the in-person estimate and tell you straight if a spot needs fixing first.
Grip is a spec choice, not a hope. We build texture into outdoor finishes and add grip to the topcoat on wet zones — pool edges, outdoor showers, and the path from the door to the water. Tell us how kids, guests, and grandparents use the space and we will set the texture for it.
Sun is the second spec. Plain epoxy ambers and chalks outside. Every outdoor floor we coat gets a sun-stable top, full stop. Water is the third: a sealed, non-porous floor hoses clean after a storm and does not hold algae the way bare, pitted concrete does.
The bare slab stained fast and felt slick when wet. We ground it, sealed it with a full-flake system, and added grip to the topcoat for wet feet.
The old deck paint was chalky and hot underfoot. We ground it back to bare concrete. Then we coated the deck with a sun-stable system and a grip finish for wet feet.
Tell us about the floor. We call back with a time to come look — the written price comes after the in-person look, before any work starts.
Rather talk? Call (352) 555-0148.
Not the way we spec it. Outdoor finishes carry texture, and wet zones get grip added to the topcoat. A smooth gloss finish around a pool is the wrong product, and we will not sell it to you.
Yes — outdoor floors get a sun-stable topcoat that does not amber like plain epoxy. That is a hard rule on this crew, not an upgrade.
The old paint comes off first. It is usually the failing layer, and coating over it just lends the new floor the old floor's problems. Grinding it off is part of the job.
Small areas price off our job minimum of $1,450. A 200 sq ft lanai in flake runs about $1,450 to $1,900 at our rates; a 600 sq ft pool deck in polyaspartic runs $4,500 to $6,600. The calculator below runs your size.
Walk times on outdoor polyaspartic tops are short — often the next day for feet, with full cure after that. Your times come in writing at the estimate, so you can plan the weekend.
Pick your floor and its size. The range updates as you go.
Add-ons your floor may need
Every floor is different. Slab condition moves the final number more than size does.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.